Neon electrode guide
The electrode is the part of a glass neon tube that carries the current into the gas. Choosing the right one for the tube diameter and current is one of the biggest factors in how long a tube lasts.
What's inside an electrode
- Shell: high purity iron, nickel plated to prevent corrosion in storage. Most types have a ceramic collar at the opening to reduce stray electron emission.
- Emissive coating: a triple carbonate coating inside the shell, converted ("activated") during bombarding.
- Glass envelope: annealed to remove strain, so it doesn't crack in use.
- Lead wires: stranded nickel on the outside for strength and easy connection.
Reading the part number
Example: 80 R P E 90
- 80: maximum current rating in mA
- R: ceramic ring (collar)
- P: tubulated (I = capped)
- E: Eurolite glass (B = lead glass, S = soda glass)
- 90: overall length in mm
Maximum and recommended current
The number in the part number is the absolute maximum running current with argon or argon/neon mixtures and mercury. For maximum life, use the lower recommended figure. With neon-filled tubes, use about 75% of the recommended figure.
| Type | Tube diameter | Recommended (blue gas) | Maximum | Shell (diameter x length) |
|---|---|---|---|---|
| EL025 | 8 to 10mm | 15 to 18mA | 25mA | 6.0 x 19.5mm |
| EL050 | 12mm | 30 to 40mA | 50mA | 7.9 x 28.5mm |
| EL080 | 15mm and above | 50 to 60mA | 80mA | 9.7 x 32.5mm |
| EL150 | 18 to 20mm | 100 to 110mA | 150mA | 12.65 x 41.5mm |
| EL250 | 20mm | 160 to 190mA | 250mA | 12.65 x 49.5mm |
Figures from Neon Products.
Why size matters
- Too small for the tube: the electrode overheats while the tube is pumped, shortening its life.
- Too large for the tube: the current needed to convert the coating during bombarding is too high for a small tube to get rid of the heat, and the phosphor coating can be damaged. For example, the EL050 should not be used on tubing smaller than 12mm, because its final conversion current (about 500mA) is too high.
Quick guide
- EL025: 8 to 10mm tubing, 15 or 20mA. Keep pumping currents low to protect the phosphors.
- EL050: 12mm tubing, up to 40mA.
- EL080: 15mm and above, up to 60mA.
- EL150: 18 to 20mm, up to 100/110mA. A good choice for cold cathode.
- EL250: 20mm, up to 190mA, for high current cold cathode. Check your bombarder has enough output.
Use the electrode picker on the calculator page to choose by tube diameter.
Glass types
Our standard electrodes are Eurolite glass. Lead and soda types are no longer manufactured; there is very limited lead stock left in clearance electrodes. Pyrex (borosilicate) types are not standard stock but can be obtained: call us.
Finishing off
Protect every electrode connection with a silicone electrode cover, and support the tube with tube supports so the electrodes aren't carrying the weight of the glass.
Shop Eurolite electrodes, or call 01892 783 900 for advice.