LED power supply guide

Choosing the right power supply is the difference between an LED sign that runs for years and one that flickers, dims at the far end or fails in the first winter. This guide covers the checks we make when sign makers call us for advice.

1. Match the voltage

Most sign LED modules and flexstrips are constant voltage, 12V or 24V DC. The supply voltage must match the LEDs exactly. A 24V supply on 12V modules will burn them out; a 12V supply on 24V modules will barely light them.

Some products, such as Hansen LED chains and LED tubes, are constant current and need a driver rated in milliamps (mA), not volts. Check the product page or datasheet. If it gives a current such as 350mA or 700mA, you need a constant current driver. Our Hansen driver picker does this for you.

2. Add up the watts, then leave headroom

Multiply the watts per module (or watts per metre for flexstrip) by the quantity. Then choose a supply that runs at no more than about 80% of its rated output. A supply working flat out runs hot and has a shorter life.

Example: 100 Eagle-1 modules at 0.36W each = 36W. 36W divided by 0.8 = 45W, so choose a supply of 45W or more.

The LED power supply calculator and LED module planner do the sums and pick an in-stock supply from our range.

3. Keep runs within the manufacturer's limit

Every module has a maximum number per run (one feed point). Beyond that, the modules at the far end get less voltage and look dimmer. For bigger letters or long runs, feed the chain from more than one point, or split it into several runs back to the supply. The maximum per run is on each module's product page and datasheet.

4. Check voltage drop on the cable

Low voltage DC loses voltage over long, thin cables. A 12V system can lose enough over a few metres to dim the modules. Keep the supply close to the LEDs, use a heavier cable for long runs, or choose 24V products for large signs. Use the voltage drop calculator to check the cable size.

5. Choose the right IP rating

  • Inside a sealed sign or indoors: an enclosed supply is fine, as long as it has airflow.
  • Outdoors, in a soffit or anywhere damp: use a waterproof supply. Our Global Power GPV supplies are IP67 and fully potted.

Make all mains and low voltage connections in a suitable enclosure, with glands or junction boxes rated for the location.

6. Think about heat and access

  • Don't seal a supply in a small box with no airflow. Heat is the main cause of early failure.
  • Mount it where it can be reached for testing and replacement.
  • Keep mains and low voltage cables apart where you can.

7. Dimming and control

Standard supplies are not dimmable. If the sign needs dimming, colour change or DMX control, plan it from the start: you'll need a dimmable supply or a separate controller between the supply and the LEDs. Our LED control range includes RGB controllers, repeaters and DMX decoders.

Quick checklist

  • Voltage matches the LEDs (12V or 24V), or the right mA driver for constant current products
  • Total load is no more than 80% of the supply rating
  • No run exceeds the manufacturer's maximum per run
  • Cable sized for the distance
  • IP rating suits the location
  • Supply can breathe and can be reached later

Not sure? Call us on 01892 783 900, Monday to Friday, 9am to 5pm, with your module, quantity and letter sizes, and we'll check it for you.